Driver for Xerox Document Centre 420 ST
Table of Contents
You can download the official driver for the Xerox Document Centre 420 ST from our website for Windows operating systems without registration. Before downloading, please identify your Windows OS version and architecture, and then use the table to download the required driver.
After downloading the driver for the Xerox Document Centre 420 ST, we strongly recommend reviewing the detailed installation instructions to avoid potential issues. If problems arise, refer to the section on “Common Errors and Solutions During Driver Installation”.
Download Driver for Xerox Document Centre 420 ST
| OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| Windows Image Acquisition Driver (WIA) | |
| Tiff Submission Tool for Windows | |
| Port Monitor, Updated | |
On this page, you can download the driver for Xerox Document Centre 420 ST! Download the necessary drivers for free for Windows, Linux, and Mac operating systems.
How to Install the Driver for Xerox Document Centre 420 ST
- Download the driver from the table for your version of Windows OS
- Run the downloaded file
- Accept the “License Agreement” and click “Next”
- Specify how you want to connect the printer to the computer and click “Next”
- Wait for the installation to complete
- Restart your computer to apply the changes.
Before installing the driver, ensure that no other version is installed on your computer. If so, remove it before proceeding with the new installation.
Common Errors and Solutions During Driver Installation
- MFU Detection Issue: If the device is not found, we recommend downloading a different version of the driver.
- MFU Problems: If the multifunction device cannot scan or print after driver installation, make sure you have restarted your computer.
- Cannot Run the Downloaded Driver File: If the file does not open, check your system for viruses and ensure the correct OS version is being used, then reboot and try again.