Driver for Xerox Document Centre 265 ST
Contents
You can download the official driver for the Xerox Document Centre 265 ST multifunction device from our website for Windows operating systems. First, you need to determine your Windows OS version and architecture before downloading the appropriate driver using the table.
After downloading the driver for the Xerox Document Centre 265 ST, we strongly recommend reviewing the detailed installation guide to avoid potential issues. If any problems arise, refer to the section on “Common Errors and Solutions During Driver Installation.”
Download Driver for Xerox Document Centre 265 ST
| OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| PCL Driver, Standard Interface Updated | |
| PS Driver, Standard Interface, Updated | |
| Windows Image Acquisition Driver (WIA) | |
On this page, you can download the driver for Xerox Document Centre 265 ST! Get the necessary drivers for Windows, Linux, and Mac for free.
How to Install the Driver for Xerox Document Centre 265 ST
- Download the driver from the table for your version of Windows
- Run the downloaded file
- Accept the “License Agreement” and click “Next”
- Specify how to connect the printer to your computer and click “Next”
- Wait for the installation to complete
- Restart your computer to apply the changes.
Before installing the driver, ensure that no other version is installed on your computer. If so, uninstall it before proceeding with the new installation.
Common Errors and Solutions During Driver Installation
- Device Detection Issue: If the multifunction device is not found, we recommend downloading a different version of the driver.
- Multifunction Device Problems: If the device does not scan or print after driver installation, make sure to restart your computer.
- Unable to Launch the Downloaded Driver File: If the file fails to open, check your system for viruses and verify the OS version, then restart and try again.