Driver for Xerox 4595
Summary
You can download the official driver for the Xerox 4595 multifunction device from our website for the Windows operating system. First, determine your Windows OS version and bitness, after which you can download the required driver using the table below.
Once you have downloaded the driver for the Xerox 4595 MFP, we strongly recommend reviewing the detailed installation instructions to avoid potential issues. If problems arise, please refer to the section “Common Installation Errors and Solutions.”
Download Driver for Xerox 4595
| Supported OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| V3 Xerox Global Print Driver PostScript x64 | |
| V3 Xerox Global Print Driver PostScript x32 | |
| V3 Xerox Global Print Driver PCL6 x64 | |
| V3 Xerox Global Print Driver PCL6 x32bit | |
On this page, you can download the Xerox 4595 driver! Download necessary drivers for Windows, Linux, and Mac operating systems for free.
How to Install the Driver for Xerox 4595
- Download the driver from the table for your Windows OS version Windows
- Run the downloaded file
- Accept the “License Agreement” and click “Next”
- Specify the method of connecting the printer to the computer and click “Next”
- Wait for the installation to finish
- Reboot your computer to apply changes.
Before installing the driver, ensure that no other version is installed on your computer. If one exists, uninstall it before proceeding with the new installation.
Common Errors and Solutions During Driver Installation
- Device detection issue: If the MFP is not found, we recommend downloading a different driver version.
- MFP issues: If the multifunction device does not scan or print after installing the driver, ensure that you have rebooted your computer.
- Unable to run the downloaded driver file: If the file fails to open, check your system for viruses, confirm that the OS version is correct, then reboot and try again.