Driver for Samsung ML-808
Summary
We present to you the official driver for the Samsung ML-808 multifunction device. This driver is essential for every owner during the initial connection of the MFP to a computer, as well as in cases of operating system reinstallation. Before downloading, you should determine the required Windows version and architecture, and then use the provided table to download the appropriate driver.
After downloading the Samsung ML-808 driver, it is highly recommended to review the installation instructions to avoid any issues. Please follow each step carefully to prevent errors. If you encounter problems, refer to the “Common Installation Issues and Solutions” section.
Download Driver for Samsung ML-808
| OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| ML-808 Print Driver | |
On this page, you can download the Samsung ML-808 driver! Download necessary drivers for your operating system — Windows, Linux, or Mac — for free.
How to Install the Driver for Samsung ML-808
- Download the driver from the table for your version of Windows OS.
- Run the downloaded file.
- Accept the “License Agreement” and click “Next”.
- Specify how to connect the printer to your computer and click “Next”.
- Wait for the installation to complete.
- Restart your computer to apply changes.
Before installing the driver, ensure that no other version is installed on your computer. If there is, uninstall it before proceeding with the new installation.
Common Installation Issues and Solutions
- Detection Issue: If the device is not found, we recommend downloading a different version of the driver.
- MFP Problems: If the multifunction device fails to scan or print after installing the driver, please ensure you have restarted your computer.
- Can’t Launch Driver File: If the file fails to open, check your system for viruses and verify that the correct OS version is being used. Then restart and try again.