Driver for Plustek OpticPro ST28
Table of Contents
You can download the official driver for the Plustek OpticPro ST28 scanner directly from our website without registration. First, determine the version of the Windows operating system that you need the driver for, then proceed with downloading the driver using the table below.
Once the download is complete, please review the installation instructions. We strongly recommend following each step carefully to avoid errors. In case of any issues, refer to the section “Common Errors and Solutions During Driver Installation.”
Download Driver for Plustek OpticPro ST28
| OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| Plustek OpticPro ST28 Driver | |
On this page, you can download the Plustek OpticPro ST28 driver! Get the necessary drivers for Windows, Linux, and Mac for free.
How to Install the Driver for Plustek OpticPro ST28
- Download the driver for your version of Windows from the table below
- Run the downloaded file
- Accept the “License Agreement” and click “Next”
- Specify how the printer is connected to the computer and click “Next”
- Wait for the installation to complete
- Restart your computer to apply the changes.
Before installing the driver, ensure that no other version of it is installed on your computer. If so, remove it before installing the new one.
Common Installation Errors and Solutions
- Scanner detection issue: If the device is not found, we recommend downloading a different version of the driver.
- Scanning problems: If the scanner does not scan after installing the driver, ensure that you have restarted your computer.
- Unable to run the downloaded driver file: If the file does not open, check your system for viruses and ensure the OS version is correct, then restart and try again.