Driver for Plustek 9636P
Table of Contents
If you need the official driver for your Canon scanner, you’ve come to the right place. This page allows you to download the official driver for the Plustek 9636P scanner, as well as offering support and essential instructions. The driver enables Windows to recognize the scanner for future use and reinstates the device to working condition.
Before downloading the driver, determine which version of Windows you require, along with the corresponding architecture and driver type. Then, use the provided table to select the appropriate driver and click the “Download” button. After downloading, proceed to installation with the straightforward instructions provided.
Download the Plustek 9636P Driver
| OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| Plustek 9636P Driver | |
On this page, you can download the Plustek 9636P driver! Download the necessary drivers for free for the Windows, Linux, and Mac operating systems.
How to Install the Plustek 9636P Driver
- Download the driver from the table based on your Windows OS version Windows
- Run the downloaded file
- Accept the “License Agreement” and click “Next”
- Specify the method of connecting the printer to the computer and click “Next”
- Wait for the installation to finish
- Restart your computer to apply the changes.
Before installing the driver, ensure that no other version is installed on your computer. If there is, uninstall it before proceeding with the new installation.
Common Installation Errors and Solutions
- Scanner detection issues: If the device is not found, consider downloading a different version of the driver.
- Scanning problems: If the scanner does not work after driver installation, make sure you have rebooted your computer.
- Unable to launch the downloaded driver file: If the file does not open, check your system for viruses and verify that the OS version is correct, then reboot and try again.