Driver for Plustek 12000P
Table of Contents
If you need the official driver for your Canon scanner, you’ve come to the right place. On this page, you can download the official driver for the Plustek 12000P scanner, as well as find support and all necessary instructions. The driver enables the Windows operating system to recognize the scanner for subsequent use and restore the device to operational status.
Before downloading the driver, determine which version of the Windows OS you need, including the bitness and type of driver. Then, using the provided table, select the appropriate driver and click the “Download” button. After downloading the driver, you can proceed with the installation using the provided installation guide.
Download Driver for Plustek 12000P
| OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| Plustek 12000P Driver | |
On this page, you can download the Plustek 12000P driver for free! Get the necessary drivers for Windows, Linux, and Mac operating systems.
How to Install the Driver for Plustek 12000P
- Download the driver from the table for your version of Windows
- Run the downloaded file
- Accept the “License Agreement” and click “Next”
- Specify how to connect the printer to your computer and click “Next”
- Wait for the installation to complete
- Restart your computer to apply changes.
Before installing the driver, ensure that no other version is installed on your computer. If it is, remove it before installing the new one.
Common Errors and Solutions During Driver Installation
- Scanner detection problem: If the device is not found, we recommend downloading a different version of the driver.
- Scanning issues: If the scanner does not function after installing the driver, make sure to restart your computer.
- Unable to run the downloaded driver file: If the file does not open, check your system for viruses and verify that your OS version is correct, then restart and try again.