Driver for Mustek BearPaw 1200TA
Summary
If you need the official driver for your Canon scanner, you’ve come to the right place. This page provides the official driver for the Mustek BearPaw 1200TA scanner, along with support and necessary instructions. The driver enables the Windows operating system to recognize the scanner for future use and restore the device to operational status.
Before downloading the driver, determine which version of the Windows OS you need, including the architecture and type of driver. Then, using the provided table, select the appropriate driver and click the “Download” button. Once the driver is downloaded, you can proceed with the installation using the easy-to-follow installation instructions.
Download Driver for Mustek BearPaw 1200TA
| OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| BearPaw 1200TA Driver | |
On this page, you can download the Mustek BearPaw 1200TA driver! Download the necessary drivers for Windows, Linux, and Mac for free.
How to Install the Driver for Mustek BearPaw 1200TA
- Download the driver for your version of Windows from the table above
- Run the downloaded file
- Accept the “License Agreement” and click “Next”
- Specify how to connect the printer to the computer and click “Next”
- Wait for the installation to complete
- Restart your computer to apply the changes.
Before installing the driver, ensure that no other version is installed on your computer. If there is, uninstall it before installing the new one.
Common Installation Errors and Solutions
- Scanner detection issue: If the device is not found, we recommend downloading a different version of the driver.
- Scanning problems: If the scanner does not scan after installing the driver, ensure you have restarted your computer.
- Unable to launch the downloaded driver file: If the file does not open, check your system for viruses and ensure the OS version is correct, then reboot and try again.