Driver for Lexmark X862
Summary
Download the official driver for the Lexmark X862 multifunction device from our website, compatible with Windows operating systems. First, identify your version and architecture of Windows, then use the table to download the appropriate driver.
After downloading the driver for the Lexmark X862 MFP, we strongly recommend reviewing the detailed installation instructions to avoid issues. If any problems occur, refer to the “Common Installation Errors and Solutions” section.
Download Driver for Lexmark X862
| OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| Lexmark Scanback Utility | |
| Universal PCL XL Emulation Print Driver v2 (3.0.3.0) | |
| Universal PCL5e Emulation Print Driver v2 (3.0.3.0) | |
| Universal PostScript 3 Emulation Print Driver v2 (3.0.3.0) | |
| Universal Print Driver Installation Package v2 (3.0.3.0) | |
On this page, you can download the Lexmark X862 driver! Free downloads available for Windows, Linux, and Mac operating systems.
How to Install the Driver for Lexmark X862
- Download the driver from the table for your version of Windows
- Run the downloaded file
- Accept the “License Agreement” and click “Next”
- Specify how to connect the printer to your computer and click “Next”
- Wait for the installation to complete
- Restart your computer to apply the changes.
Before installing the driver, ensure that no other version is installed on your computer. If there is, remove it before installing the new one.
Common Installation Errors and Solutions
- MFP Detection Issue: If the device is not found, we recommend downloading a different version of the driver.
- MFP Issues: If the multifunction device fails to scan or print after driver installation, ensure you have restarted your computer.
- Cannot Launch the Downloaded Driver File: If the file does not open, check your system for viruses and ensure the OS version is correct, then restart and try again.