Driver for Lexmark X772
Summary
You can download the official driver for the Lexmark X772 multifunction device from our website without registration. Please identify your Windows OS version and architecture before downloading, and refer to the provided table to get the appropriate driver.
After downloading the driver for the Lexmark X772, we strongly recommend reviewing the detailed installation instructions to avoid potential issues. If you encounter any problems, please refer to the “Common Installation Errors and Solutions” section.
Download Driver for Lexmark X772
| OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| Lexmark Scanback Utility | |
| Universal Print Driver Installation Package v2 (3.0.3.0) | |
| Universal PCL5e Emulation Print Driver v2 (3.0.3.0) | |
| Universal PostScript 3 Emulation Print Driver v2 (3.0.3.0) | |
On this page, you can download the Lexmark X772 driver! Download the required drivers for Windows, Linux, and Mac for free.
How to Install the Driver for Lexmark X772
- Download the driver from the table for your version of Windows OS
- Run the downloaded file
- Accept the “License Agreement” and click “Next”
- Select the method to connect the printer to the computer, then click “Next”
- Wait for the installation to complete
- Restart your computer to apply the changes.
Before installing the driver, ensure that no other version is installed on your computer. If so, please remove it before proceeding with the new installation.
Common Installation Errors and Solutions
- Device detection issue: If the multifunction device is not found, we recommend downloading an alternative version of the driver.
- Multifunction device issues: If the device fails to scan or print after driver installation, make sure to restart your computer.
- Unable to launch the downloaded driver file: If the file fails to open, check your system for viruses, ensure the correct OS version is being used, then restart and try again.