Driver for Lexmark X466
Table of Contents
You can download the official driver for the Lexmark X466 multifunction device from our website for Windows operating systems without needing registration. Before downloading, please identify your Windows version and architecture, then use the table to download the required driver.
After downloading the driver for the Lexmark X466 multifunction device, we strongly recommend reviewing the detailed installation instructions to avoid potential issues. If any problems arise, refer to the “Common Errors and Solutions During Driver Installation” section.
Download Driver for Lexmark X466
| OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| Lexmark Scanback Utility | |
| Universal PCL XL Emulation Print Driver v2 (3.0.3.0) | |
| Universal PCL XL Emulation Print Driver v2 (3.0.3.0) | |
On this page, you can download the Lexmark X466 driver! Download the necessary drivers for Windows, Linux, and Mac for free.
How to Install the Driver for Lexmark X466
- Download the driver from the table for your version of Windows OS
- Run the downloaded file
- Accept the “License Agreement” and click “Next”
- Select how to connect the printer to your computer and click “Next”
- Wait for the installation to complete
- Restart your computer to apply the changes.
Before installing the driver, ensure that no other version is installed on your computer. If it is, please uninstall it before proceeding with the new installation.
Common Installation Errors and Solutions
- Device not detected: If the multifunction device is not found, we recommend downloading a different version of the driver.
- Issues with the multifunction device: If the device does not scan or print after driver installation, please ensure your computer has been restarted.
- Unable to run the downloaded driver file: If the file does not open, check your system for viruses, verify that the correct OS version is being used, then restart and try again.