Driver for Lexmark X463
Table of Contents
You can download the official driver for the Lexmark X463 multifunction device from our website for Windows without registration. Before downloading, make sure to identify the version and architecture of your Windows operating system, and then use the table to download the required driver.
After downloading the driver for the Lexmark X463, we highly recommend reading the detailed installation instructions to avoid potential issues. If problems arise, please refer to the “Common Installation Errors and Solutions” section.
Download Driver for Lexmark X463
| Supported OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| Lexmark Scanback Utility | |
| Universal Print Driver Installation Package v2 (3.0.3.0) | |
| Universal PCL XL Emulation Print Driver v2 (3.0.3.0) | |
On this page, you can download the Lexmark X463 driver! Download required drivers for Windows, Linux, and Mac for free.
How to Install the Driver for Lexmark X463
- Download the driver from the table for your version of the Windows operating system.
- Run the downloaded file.
- Accept the “License Agreement” and click “Next.”
- Specify how you will connect the printer to your computer and click “Next.”
- Wait for the installation to complete.
- Restart your computer to apply the changes.
Before installing the driver, ensure that no other version is installed on your computer. If one is present, remove it before installing the new version.
Common Errors and Solutions During Driver Installation
- Detection issues: If the device is not found, it is advisable to download a different version of the driver.
- Multifunctional device issues: If the device does not scan or print after driver installation, please ensure you have restarted your computer.
- Unable to run the downloaded driver file: If the file does not open, check your system for viruses and verify that the operating system version is correct, then restart and try again.