Driver for Lexmark X443
Overview
You can download the official driver for the Lexmark X443 multifunction device from our website for Windows operating systems without registration. Before downloading, please determine your version of Windows and its architecture, then use the table to download the required driver.
After downloading the driver for the Lexmark X443, we strongly recommend reviewing the detailed installation instructions to avoid any issues. In case of problems, please refer to the section “Common Issues and Solutions During Driver Installation.”
Download the Driver for Lexmark X443
| OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| Lexmark Scanback Utility | |
| Universal Print Driver Installation Package v2 (3.0.3.0) | |
| Universal PCL XL Emulation Print Driver v2 (3.0.3.0) | |
On this page, you can download the Lexmark X443 driver! Download necessary drivers for Windows, Linux, and Mac for free.
How to Install the Driver for Lexmark X443
- Download the driver from the table that matches your version of Windows
- Run the downloaded file
- Accept the “License Agreement” and click “Next”
- Specify how the printer is connected to your computer and click “Next”
- Wait for the installation to complete
- Restart your computer to apply the changes.
Before installing the driver, ensure that no other version is installed on your computer. If one exists, please remove it before proceeding with the new installation.
Common Issues and Solutions During Driver Installation
- Device Not Detected: If the multifunction device is not found, consider downloading a different version of the driver.
- Device Issues: If the multifunction device is not scanning or printing after installation, ensure that you have restarted your computer.
- Unable to Launch the Downloaded Driver File: If the file does not open, check your system for viruses, confirm the OS version is correct, then restart and try again.