Driver for Lexmark P6200
Summary
Here we present the official driver for the Lexmark P6200 multifunction device, which is essential for every owner during the initial connection of the MFP to a computer, as well as in the event of an operating system reinstall. Before downloading the driver, determine the required version and architecture of Windows, and then use the convenient table to download the corresponding driver.
After downloading the driver for the Lexmark P6200, we strongly recommend reading the installation instructions to avoid potential issues. Please follow each step carefully to prevent errors, and if problems arise, refer to the “Common Installation Errors and Solutions” section.
Download Driver for Lexmark P6200
| OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| Imaging devices Driver x64bit | |
| Imaging devices Driver x32bit | |
On this page, you can download the Lexmark P6200 driver! Download the necessary drivers for Windows, Linux, and Mac operating systems for free.
How to Install the Driver for Lexmark P6200
- Download the driver from the table for your version of Windows
- Run the downloaded file
- Accept the “License Agreement” and click “Next”
- Specify how the printer is connected to the computer and click “Next”
- Wait for the installation to complete
- Restart your computer to apply the changes.
Before installing the driver, ensure that no other version is installed on your computer. If one exists, remove it before installing the new version.
Common Installation Errors and Solutions
- MFP Detection Issue: If the device is not found, we recommend downloading a different version of the driver.
- MFP Issues: If the multifunction device does not scan or print after driver installation, make sure you have restarted your computer.
- Cannot Run the Downloaded Driver File: If the file doesn’t open, check your system for viruses and ensure the OS version is correct, then restart and try again.