Driver for Lexmark P3120
Table of Contents
We present the official driver for the multifunctional device Lexmark P3120. This driver is essential for every owner when initially connecting the MFP to a computer or following a reinstallation of the operating system. Before downloading the driver, please determine the appropriate version and architecture of Windows. After that, utilize the convenient table to download the corresponding driver.
Once you have downloaded the driver for the Lexmark P3120, we strongly recommend reviewing the installation instructions to avoid potential issues. Follow each step carefully to prevent mistakes, and in case of issues, refer to the section “Common Installation Errors and Solutions.”
Download Driver for Lexmark P3120
| OS Versions: Windows 11, Windows 10 (32-bit and 64-bit), Windows 8.1 (32-bit and 64-bit), Windows 8 (32-bit and 64-bit), Windows 7 (32-bit and 64-bit) | |
| Driver Type | Download |
| Imaging Devices | |
On this page, you can download the Lexmark P3120 driver! Download essential drivers for operating systems Windows, Linux, and Mac for free.
How to Install the Driver for Lexmark P3120
- Download the driver from the table for your version of the Windows OS
- Run the downloaded file
- Accept the “License Agreement” and click “Next”
- Specify how you will connect the printer to the computer and click “Next”
- Wait for the installation to complete
- Reboot your computer to apply the changes.
Before installing the driver, please ensure that no other version is installed on your computer. If there is, remove it before proceeding with the new installation.
Common Installation Errors and Solutions
- MFU Detection Issue: If the device is not found, try downloading a different version of the driver.
- MFU Problems: If the multifunction device does not scan or print after installing the driver, ensure that you have rebooted your computer.
- Unable to Run the Downloaded Driver File: If the file does not open, check your system for viruses and verify the operating system version. Then reboot and try again.