Driver for Lexmark MX722
Table of Contents
Introducing the official driver for the Lexmark MX722 multifunction device, essential for every owner when first connecting the MFP to a computer, or after reinstalling the operating system. Before downloading, determine the appropriate version and architecture of Windows, then use the convenient table to download the corresponding driver.
After downloading the Lexmark MX722 driver, we strongly recommend reviewing the installation instructions to avoid issues. Follow each step meticulously to prevent errors, and should any arise, refer to the “Common Errors and Solutions” section.
Download Driver for Lexmark MX722
| Supported OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| Lexmark Printer Software G3 Drivers (Print and Scan) | |
On this page, you can download the Lexmark MX722 driver! Download required drivers for Windows, Linux, and Mac operating systems at no cost.
How to Install the Driver for Lexmark MX722
- Download the driver from the table for your version of Windows
- Run the downloaded file
- Agree to the “License Agreement” and click “Next”
- Specify how the printer is connected to the computer and click “Next”
- Wait for the installation to complete
- Restart your computer to apply the changes.
Before installing the driver, ensure that no other version is installed on your computer. If so, remove it before proceeding with the new installation.
Common Installation Errors and Solutions
- Device detection issues: If the device is not found, try downloading a different version of the driver.
- MFP problems: If the multifunction device is unable to scan or print after the driver installation, make sure you have restarted your computer.
- Unable to run the downloaded driver file: If the file does not open, check your system for viruses, ensure the correct OS version is being used, then restart and try again.