Driver for Lexmark MX710
Table of Contents
We present the official driver for the Lexmark MX710 multifunctional device, essential for every user upon first connecting the MFP to a computer, or after reinstalling the operating system. Before downloading the driver, determine the appropriate version and architecture of Windows needed, and then use the convenient table to download the corresponding driver.
After downloading the Lexmark MX710 driver, we strongly recommend reviewing the installation instructions to avoid potential issues. Please follow each step carefully to prevent errors, and if issues arise, refer to the section “Common Installation Errors and Solutions.”
Download Driver for Lexmark MX710
| OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| Lexmark MX710 Series Driver and Software | |
On this page, you can download the Lexmark MX710 driver! Download the necessary drivers for Windows, Linux, and Mac operating systems free of charge.
How to Install the Driver for Lexmark MX710
- Download the driver from the table based on your Windows version.
- Run the downloaded file.
- Accept the “License Agreement” and click “Next.”
- Specify the method of connecting the printer to the computer and click “Next.”
- Wait for the installation to complete.
- Restart your computer to apply changes.
Before installing the driver, ensure that no other version is installed on your computer. If one exists, remove it before proceeding with the new installation.
Common Installation Errors and Solutions
- Device not detected: If the device is not found, we recommend downloading a different driver version.
- Issues with multifunctional device: If the MFP cannot scan or print after installing the driver, make sure you have restarted your computer.
- Unable to launch the downloaded driver file: If the file won’t open, check your system for viruses and verify that the OS version is correct, then reboot and try again.