Driver for Kyocera KM-3530
Table of Contents
We present the official driver for the Kyocera KM-3530 multifunction device, essential for every owner when connecting the MFP to a computer for the first time or after reinstalling the operating system. Before downloading the driver, determine the required version and architecture of Windows, and then use the convenient table to download the appropriate driver.
After downloading the driver for the Kyocera KM-3530, we highly recommend reviewing the installation instructions to avoid potential issues. Please follow each step carefully to prevent errors, and if problems arise, refer to the “Common Installation Errors and Solutions” section.
Download Driver for Kyocera KM-3530
| OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| KX KM-3530 Driver | |
On this page, you can download the Kyocera KM-3530 driver! Get the necessary drivers for Windows, Linux, and Mac operating systems for free.
How to Install the Kyocera KM-3530 Driver
- Download the driver from the table corresponding to your version of Windows.
- Run the downloaded file.
- Accept the “License Agreement” and click “Next.”
- Select the method to connect the printer to your computer, then click “Next.”
- Wait for the installation to complete.
- Restart your computer to apply the changes.
Before installing the driver, ensure that no other version is already installed on your computer. If it is, please remove it before proceeding with the new installation.
Common Installation Errors and Solutions
- Detection Issues: If the MFP is not found, we recommend downloading a different version of the driver.
- MFP Issues: If the multifunction device fails to scan or print after installing the driver, please ensure that you have restarted your computer.
- Driver File Won’t Open: If the downloaded file won’t open, check your system for viruses, verify that the OS version is correct, then restart and try again.