Driver for HP ENVY 121
Contents
This is the official driver for the HP ENVY 121 printer, necessary for the initial connection of the device to your computer, as well as for reinstalling the Windows operating system. This driver enables Windows to recognize the printer for printing capabilities. Additionally, software or utilities for printer setup are included.
To download the driver for HP ENVY 121, select the appropriate version for your Windows operating system and its architecture. If you encounter any issues, we recommend reviewing the installation instructions carefully and following them closely.
Download Driver for HP ENVY 121
| OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| HP ENVY 120 e-All-in-One Printer Full Feature Software and Drivers | |
| HP ENVY 120 e-All-in-One Printer Basic Driver | |
| HP Print and Scan Doctor for Windows | |
On this page, you can download the HP ENVY 121 driver! Download the necessary drivers for free for your Windows, Linux, and Mac operating systems.
How to Install the Driver for HP ENVY 121
- Download the driver from the table for your Windows OS version
- Run the downloaded file
- Accept the “License Agreement” and click “Next”
- Specify how you will connect the printer to the computer and click “Next”
- Wait for the installation to complete
- Restart your computer to apply the changes.
Before installing the driver, ensure that no other version is already installed on your computer. If so, remove it before proceeding with the new installation.
Common Errors and Solutions During Driver Installation
- Printer detection issue: If the device is not found, we recommend downloading a different version of the driver.
- Printing issues: If the printer does not print after driver installation, make sure you have restarted your computer.
- Unable to run the driver file: If the file does not open, check your system for viruses, then restart and try again.