Driver for HP Deskjet 350c
Contents
The official driver for the HP Deskjet 350c printer is essential for the initial connection of the device to your computer and for reinstalling the Windows operating system. This driver enables the system to recognize the printer for subsequent use, as well as setup and printing. The installation process is automatic and should be hassle-free; however, it is important to restart your computer afterward to apply the changes.
You can download the driver for the HP Deskjet 350c for your specific operating system version from the table below, after which we recommend reviewing the installation instructions.
Download Driver for HP Deskjet 350c
| OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| HP Deskjet 350 series PCL 3 printer driver | |
| Deskjet 350C and 350Cbi PCL 3 driver (Add Printer, WHQL certified) | |
On this page, you can download the HP Deskjet 350c driver! Download the necessary drivers for free for Windows, Linux, and Mac operating systems.
How to Install the Driver for HP Deskjet 350c
- Download the driver from the table for your version of Windows
- Run the downloaded file
- Accept the “End User License Agreement” and click “Next”
- Specify how the printer will be connected to the computer and click “Next”
- Wait for the installation to complete
- Restart your computer to apply the changes.
Before installing the driver, ensure that any previous versions are uninstalled from your computer. If one exists, remove it before proceeding with the new installation.
Common Installation Issues and Solutions
- Printer Detection Issues: If the device is not found, we recommend downloading a different version of the driver.
- Printing Problems: If the printer does not print after driver installation, make sure you’ve rebooted your computer.
- Unable to Launch Driver File: If the file does not open, scan your system for viruses, then restart and try again.