Driver for Epson Perfection 3590 Photo
Table of Contents
You can download the official driver for the Epson Perfection 3590 Photo scanner directly from our website without registration. First, determine which version of the Windows operating system you need the driver for, and then you can proceed to download the driver using the table below.
After successfully downloading, you can review the installation instructions. We advise following each step carefully to avoid errors. If any issues arise, please refer to the “Common Errors and Solutions During Driver Installation” section.
Download Driver for Epson Perfection 3590 Photo
| Supported OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| Scanner Driver and EPSON Scan Utility v3.04A | |
| Epson Event Manager v3.11.77 | |
On this page, you can download the Epson Perfection 3590 Photo driver! Download the necessary drivers for the Windows, Linux, or Mac operating systems free of charge.
How to Install the Driver for Epson Perfection 3590 Photo
- Download the driver from the table corresponding to your version of Windows.
- Run the downloaded file.
- Accept the “License Agreement” and click “Next.”
- Specify the method of connecting the printer to your computer and click “Next.”
- Wait for the installation to complete.
- Restart your computer to apply the changes.
Before installing the driver, ensure that no other version is installed on your computer. If there is, remove it before proceeding with the new installation.
Common Installation Errors and Solutions
- Scanner Detection Issue: If the device is not found, try downloading a different version of the driver.
- Scanning Problems: If the scanner does not function after installing the driver, ensure your computer was restarted.
- Unable to Open the Downloaded Driver File: If the file fails to open, check your system for viruses and ensure the correct OS version is used, then restart and try again.