Driver for Epson ET-M2170
Table of Contents
You can download the official driver for the Epson ET-M2170 multifunction device from our website for the Windows operating system. First, determine your Windows version and architecture, then use the table below to download the appropriate driver.
After downloading the driver for the Epson ET-M2170, we strongly recommend reviewing the detailed installation instructions to avoid any issues. If problems arise, refer to the section on “Common Errors and Solutions during Driver Installation.”
Download Driver for Epson ET-M2170
| OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| Drivers and Utilities Combo Package Installer | |
| Printer Driver v2.63.02 x64bit | |
| Printer Driver v2.63.02 x32bit | |
| Scanner Driver and Epson Scan 2 Utility v6.5.23.0 | |
| Epson Software Updater v4.6.7 | |
On this page, you can download the Epson ET-M2170 driver! Get the necessary drivers for Windows, Linux, and Mac for free.
How to Install the Driver for Epson ET-M2170
- Download the driver from the table for your version of Windows
- Run the downloaded file
- Accept the “License Agreement” and click “Next”
- Specify how you will connect the printer to your computer and click “Next”
- Wait for the installation to complete
- Restart your computer to apply the changes.
Before installing the driver, ensure that no other version is installed on your computer. If there is, remove it before installing the new one.
Common Installation Errors and Solutions
- Multifunction Device Detection Issue: If the device is not found, we recommend downloading a different version of the driver.
- Multifunction Device Problems: If the device does not scan or print after installing the driver, make sure you have restarted your computer.
- Unable to Open the Downloaded Driver File: If the file does not open, check your system for viruses, verify the OS version, then restart and try again.