Driver for Epson ET-5800
Table of Contents
You can download the official driver for the Epson ET-5800 multifunction device from our website for Windows operating system. First, determine your Windows OS version and architecture, then use the table to download the appropriate driver.
After downloading the driver for the Epson ET-5800, we strongly recommend reviewing the detailed installation instructions to avoid potential issues. If problems arise, refer to the “Common Installation Errors and Solutions” section.
Download Driver for Epson ET-5800
| OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| Drivers and Utilities Combo Package Installer | |
| Printer Driver v3.05.00 x64bit | |
| Printer Driver v3.05.00 x32bit | |
| Scanner Driver and Epson Scan 2 Utility v6.7.45.0 | |
| Epson Software Updater v4.6.7 | |
On this page, you can download the Epson ET-5800 driver! Download necessary drivers for free for Windows, Linux, and Mac operating systems.
How to Install the Driver for Epson ET-5800
- Download the driver from the table for your OS version Windows
- Run the downloaded file
- Accept the “End User License Agreement” and click “Next”
- Specify how to connect the printer to your computer and click “Next”
- Wait for the installation to complete
- Restart your computer to apply the changes.
Before installing the driver, ensure that no other version is already installed on your computer. If so, remove it before installing the new version.
Common Installation Errors and Their Solutions
- Device Detection Issue: If the device is not found, we recommend downloading a different version of the driver.
- Device Issues: If the multifunction device does not scan or print after installing the driver, ensure you have restarted your computer.
- Unable to Launch Downloaded Driver File: If the file doesn’t open, check your system for viruses and verify that your OS version is correct. Then restart and try again.