Driver for Canon iR6000i
Overview
You can download the official driver for the Canon iR6000i multifunction device from our website without registration. Before downloading, please identify your version of Windows and its architecture, then use the table to download the appropriate driver.
After downloading the driver for the Canon iR6000i, we highly recommend reviewing the detailed installation instructions to avoid any issues. If you do encounter problems, please refer to the “Common Installation Errors and Solutions” section.
Download Driver for Canon iR6000i
| OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| [Windows 32bit & 64bit] PCL6 Printer Driver V15.00 | |
| [Windows 32bit & 64bit] PostScript 3 Printer Driver V15.00 | |
| [Windows] PPD File V5.20 | |
On this page you can download the Canon iR6000i driver! Freely download the necessary drivers for Windows, Linux, and Mac operating systems.
How to Install the Driver for Canon iR6000i
- Download the driver from the table for your version of Windows
- Run the downloaded file
- Accept the “License Agreement” and click “Next”
- Specify how the printer will be connected to the computer and click “Next”
- Wait for the installation to complete
- Restart your computer to apply the changes.
Before installing the driver, ensure that no other version is already installed on your computer. If there is, please remove it before proceeding with the new installation.
Common Errors and Solutions During Driver Installation
- Device detection issue: If the device is not found, we recommend downloading a different version of the driver.
- Printer issues: If the multifunction device fails to scan or print after driver installation, ensure that you have restarted your computer.
- Unable to run the downloaded driver file: If the file won’t open, check your system for viruses and verify that the correct OS version is being used, then restart and try again.