Driver for Canon iR1022F
Table of Contents
You can download the official driver for the Canon iR1022F multifunction device from our website for Windows without registration. Before downloading, you need to identify your Windows operating system version and architecture, and then use the table to download the required driver.
After downloading the Canon iR1022F driver, we strongly recommend reviewing the detailed installation instructions to avoid potential issues. If you encounter any problems, please refer to the section “Frequent Installation Errors and Solutions.”
Download Driver for Canon iR1022F
| OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| [Windows 32bit & 64bit] PCL6 Printer Driver V15.00 | |
| [Windows 32bit & 64bit] UFRII Printer Driver V15.00 | |
| Lite Plus PCL6 Printer Driver | |
| Canon Generic Fax Driver v10.06 | |
On this page, you can download the Canon iR1022F driver! Download the necessary drivers for Windows, Linux, and Mac free of charge.
How to Install the Canon iR1022F Driver
- Download the driver from the table for your Windows OS version.
- Run the downloaded file.
- Accept the “License Agreement” and click “Next.”
- Specify how you will connect the printer to the computer and click “Next.”
- Wait for the installation to complete.
- Restart your computer to apply changes.
Before installing the driver, ensure that no other version is installed on your computer. If it is present, remove it before installing the new version.
Common Installation Errors and Solutions
- MFU Detection Issues: If the device is not found, we recommend downloading a different version of the driver.
- MFU Problems: If the multifunction device fails to scan or print after driver installation, ensure that you have restarted your computer.
- Unable to Launch Downloaded Driver File: If the file does not open, check your system for viruses, verify the correct OS version, then restart and try again.