Driver for Canon imageRUNNER C6800
Table of Contents
You can download the official driver for the Canon imageRUNNER C6800 multifunction printer from our site for Windows operating systems without registration. Before downloading, identify your Windows version and architecture, then use the table to obtain the necessary driver.
After downloading the driver for the Canon imageRUNNER C6800, we strongly recommend that you read the detailed installation instructions to avoid any issues. If problems arise, please refer to the “Common Installation Errors and Solutions” section.
Download Driver for Canon imageRUNNER C6800
| Operating System Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| [Windows] PPD File V5.10 | |
| [Windows 32bit & 64bit] PostScript 3 Printer Driver V15.00 | |
On this page, you can download the Canon imageRUNNER C6800 driver! Download the necessary drivers for Windows, Linux, and Mac operating systems for free.
How to Install the Driver for Canon imageRUNNER C6800
- Download the driver from the table for your version of Windows
- Run the downloaded file
- Accept the “License Agreement” and click “Next”
- Specify how to connect the printer to your computer and click “Next”
- Wait for the installation to complete
- Restart your computer to apply changes.
Before installing the driver, ensure that no previous version is installed on your computer. If so, please uninstall it before proceeding with the new installation.
Common Installation Errors and Solutions
- Device Detection Issue: If the multifunction printer is not found, try downloading a different version of the driver.
- Printer Malfunction: If the multifunction printer does not scan or print after the driver installation, make sure to restart your computer.
- Unable to Launch the Downloaded Driver File: If the file does not open, scan your system for viruses and check if the operating system version is correct, then restart and try again.