Driver for Canon i-SENSYS LBP113w
Overview
You can download the official driver for the Canon i-SENSYS LBP113w multifunction device from our website for Windows operating systems without registration. Before downloading, identify your Windows version and architecture, then use the table to download the appropriate driver.
After downloading the driver for the Canon i-SENSYS LBP113w, we strongly recommend reviewing the detailed installation instructions to avoid potential problems. If issues arise, please refer to the “Common Installation Issues and Solutions” section.
Download Driver for Canon i-SENSYS LBP113w
| Supported OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| LBP113w UFRII LT Printer Driver Ver.30.10 | |
| [Windows] Laser NW Device Setup Utility V1.20 | |
On this page, you can download the Canon i-SENSYS LBP113w driver! Download the necessary drivers for Windows, Linux, and Mac for free.
How to Install the Driver for Canon i-SENSYS LBP113w
- Download the driver from the table for your version of Windows OS
- Run the downloaded file
- Accept the “License Agreement” and click “Next”
- Select the connection method for the printer and click “Next”
- Wait for the installation to complete
- Restart your computer to apply the changes.
Before installing the driver, ensure that no other version is installed on your computer. If one exists, uninstall it before proceeding with the new installation.
Common Issues and Solutions During Driver Installation
- Device Detection Issue: If the multifunction device is not found, we recommend downloading a different version of the driver.
- Multifunction Device Problems: If the device fails to scan or print after driver installation, ensure that you have rebooted your computer.
- Unable to Launch the Downloaded Driver File: If the file does not open, check your system for viruses and ensure the correct OS version is being used. Then restart and try again.