Driver for Canon CanoScan LiDE 60
Table of Contents
On our site, you can download the official driver for the Canon CanoScan LiDE 60 scanner, essential for recognizing the device and enabling high-quality document and photo scanning. First, determine which version of the Windows operating system the driver is needed for, then use the provided table to select the corresponding driver and click “Download.”
After successfully downloading the driver for the Canon CanoScan LiDE 60, you can proceed with the installation using the provided instructions. If you encounter errors, we recommend checking the “Common Errors and Solutions during Driver Installation” section.
Download Driver for Canon CanoScan LiDE 60
| OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| ScanGear CS x32 | |
| ScanGear CS x64 | |
| CanoScan Toolbox | |
On this page, you can download the Canon CanoScan LiDE 60 driver! Download the necessary drivers for Windows, Linux, Mac operating systems for free.
How to Install the Driver for Canon CanoScan LiDE 60
- Download the driver from the table for your Windows OS version.
- Run the downloaded file.
- Accept the “License Agreement” and click “Next.”
- Specify how you will connect the printer to the computer and click “Next.”
- Wait for the installation to complete.
- Restart your computer to apply the changes.
Before installing the driver, make sure no other version is installed on your computer. If it is, remove it before installing the new one.
Common Errors and Solutions during Driver Installation
- Scanner detection issue: If the device is not found, try downloading a different version of the driver.
- Scanning problems: If the scanner does not scan after driver installation, ensure that you have restarted your computer.
- Unable to launch the downloaded driver file: If the file does not open, check your system for viruses, ensure the OS version is correct, then restart and try again.