Driver for Brother DCP-J4120DW
Summary
You can download the official driver for the Brother DCP-J4120DW multifunction device from our website, compatible with the Windows operating system. First, determine your Windows OS version and architecture, then use the table to download the required driver.
After downloading the driver for the Brother DCP-J4120DW, we strongly recommend reviewing the detailed installation instructions to avoid any potential issues. If problems arise, please refer to the section on “Common Installation Errors and Solutions.”
Download Driver for Brother DCP-J4120DW
| OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| Full Driver & Software Package (Recommended) | |
| Printer Driver & Scanner Driver for Local Connection | |
| BRAgent | |
| Uninstall Tool | |
On this page, you can download the Brother DCP-J4120DW driver! Download the necessary drivers for Windows, Linux, and Mac at no cost.
How to Install the Driver for Brother DCP-J4120DW
- Download the driver from the table for your version of Windows
- Run the downloaded file
- Accept the “License Agreement” and click “Next”
- Specify how to connect the printer to your computer and click “Next”
- Wait for the installation to complete
- Restart your computer to apply the changes.
Before installing the driver, ensure that no other version is already installed on your computer. If so, please remove it prior to proceeding with the new installation.
Common Errors and Solutions During Driver Installation
- Device Detection Issue: If the device is not found, it is advisable to download a different driver version.
- Device Malfunction: If the multifunction device fails to scan or print after driver installation, ensure that you have restarted your computer.
- Unable to Launch Downloaded Driver File: If the file does not open, check your system for viruses and confirm that the correct OS version is in use, then restart and try again.