Driver for Brother DCP-165C
Table of Contents
Download the official driver for the Brother DCP-165C multifunction device from our website for the Windows operating system. First, determine your version of Windows and its architecture, then refer to the table to download the required driver.
After downloading the driver for the Brother DCP-165C, we strongly recommend reviewing the detailed installation instructions to avoid any issues. If problems arise, please refer to the section on “Common Errors and Solutions During Driver Installation.”
Download Driver for Brother DCP-165C
| OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| Full Driver & Software Package (Recommended) | |
| Printer & Scanner Driver for Local Connection x64 | |
| Printer & Scanner Driver for Local Connection x32 | |
| Uninstall Tool | |
On this page, you can download the Brother DCP-165C driver! Download the necessary drivers for free for Windows, Linux, and Mac operating systems.
How to Install the Driver for Brother DCP-165C
- Download the driver from the table corresponding to your version of Windows
- Run the downloaded file
- Accept the “License Agreement” and click “Next”
- Specify the printer connection method to the computer and click “Next”
- Wait for the installation to complete
- Restart your computer to apply the changes.
Before installing the driver, ensure that no other version is installed on your computer. If so, uninstall it before installing the new one.
Common Installation Issues and Solutions
- Device detection issue: If the device is not found, it is advisable to download a different driver version.
- Device issues: If the multifunction device does not scan or print after driver installation, ensure that you have restarted your computer.
- Unable to launch the downloaded driver file: If the file does not open, check your system for viruses and make sure the OS version is correct. Then restart and try again.