Driver for Brother DCP-153C
Table of Contents
You can download the official driver for the Brother DCP-153C multifunction device from our website for Windows operating systems. First, determine the version and architecture of your Windows OS, and then use the table to download the appropriate driver.
After downloading the driver for the Brother DCP-153C, it is highly recommended to review the detailed installation instructions to avoid potential issues. If problems arise, please refer to the “Common Errors and Solutions during Driver Installation” section.
Download Driver for Brother DCP-153C
| OS Versions: Windows 11, Windows 10 32-bit, Windows 10 64-bit, Windows 8.1 32-bit, Windows 8.1 64-bit, Windows 8 32-bit, Windows 8 64-bit, Windows 7 32-bit, Windows 7 64-bit | |
| Driver Type | Download |
| Full Driver & Software Package (Recommended) | |
| Printer Driver & Scanner Driver for Local Connection x64 | |
| Printer Driver & Scanner Driver for Local Connection x32 | |
| Uninstall Tool | |
On this page, you can download the Brother DCP-153C driver! Download the necessary drivers for Windows, Linux, and Mac for free.
How to Install the Driver for Brother DCP-153C
- Download the driver from the table for your Windows OS version.
- Run the downloaded file.
- Accept the “License Agreement” and click “Next.”
- Select the method of connecting the printer to the computer and click “Next.”
- Wait for the installation to complete.
- Restart your computer to apply the changes.
Before installing the driver, ensure that no other version is installed on your computer. If there is, remove it before installing the new one.
Common Errors and Solutions during Driver Installation
- Device Detection Issue: If the device is not found, try downloading a different driver version.
- Device Problems: If the multifunction device is not scanning or printing after driver installation, ensure that you have restarted your computer.
- Cannot Open Downloaded Driver File: If the file does not open, check your system for viruses and ensure the OS version is correct, then reboot and try again.